EN
Care and maintenance
Descaling procedure
1
Warning: For safety reasons, the descaling
process cannot be interrupted and it takes
about 45 minutes.
The appliance can be descaled with the appliance
door open or closed. The appliance must be in
idle state prior to starting the descaling cycle.
To run a descaling cycle proceed as follows:
1. Press the "On/Off" key to switch the oven on.
2. Press the "Left" and "Right" keys at the same
time for 5 seconds. The display shows "CAL"
and there is an intermittent beep.
(If you wish to cancel the descale process at
this stage press the "Stop" key.)
3. Press the Start key.
4. When the display shows "0.5L", remove the
water tank.
5. Pour 0,5 litres of an adequate descaling
solution into the water tank and put the water
tank back.
6. Press the "Start" key. The Descale cycle is
initiated and takes about 45 minutes.
52
CA L
7. When the display shows "1.0L" flashing and
the oven emits a beep, remove and empty the
water tank.
8. Fill the water tank with 1,0 litres of cold water
and put the water tank back.
9. Press the "Start" key. The first rinsing cycle
starts.
10. When the display again shows "1.0L" flashing
and the oven emits a new beep, remove and
empty the water tank.
11. Fill the water tank with 1.0 litres of cold water
and put the water tank back.
12. Press the "Start" key. The second rinsing
cycle starts.
13. When the rinsing cycle has finished the
display shows "End".
14. Remove, empty and dry the water tank.
2
3, 6, 9, 12