Basic Settings; Initial Settings; Setting The Clock - Foster FL F46 VAPORE Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30

Basic settings

Initial Settings

After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock, the water
hardness parameter and the Calibration is set.

Setting the clock

The clock display will flash if your appliance is first plugged in or after a power failure, to indicate that the
time shown is not correct. To set the clock, proceed as follows:
1
To set the clock, proceed as follows:
1. Press the "On/Off" key to switch the oven on.
2. Hold down the "–" and "+" keys simultaneously.
The hour digits will flash (steps 1 and 2 are not
necessary when the oven is first plugged in or
after a power failure).
Water Hardness setting
1
The appliance features a system that automatically
indicates when it is time to descale.
The system can be optimised for households with
very soft water (also through using a water softening
appliance) and very hard water, by changing the user
settings to the relevant range of water hardness (see
table below).
To set the water hardness parameter, proceed as
follows:
1. Press the "On/Off" key to switch the oven on.
To set the clock and the water hardness
parameter value proceed as described in the
following chapters.
13 : 4 8
3. Press the "–" and "+" keys to set the hours.
4. Press the OK key to confirm the hours. The
minutes digits will flash.
5. Press the "–" and "+" keys to set the minutes.
6. Press the OK key to confirm the minutes.
13 : 4 8
2. Press the "<" and ">" keys ("Left" and "Right") at
the same time. The hardness level will start to flash
on the display (steps 1 and 2 are not necessary if
your microwave oven is first plugged in or after a
power failure).
3. Press the "–" and "+" keys to set the correct water
hardness parameter value, according to the below
table.
4. Press the "OK" key to set the parameter. The
display shows the clock.
2,3,5
3
2
EN
4,6
4
35

Publicidad

Tabla de contenido
loading

Tabla de contenido