Items Supplied; Before Using For The First Time - Silvercrest SDRB 1000 C1 Instrucciones De Servicio

__NAS279803_Dampfbuerste_B5.book Seite 42 Freitag, 24. Juni 2016 1:43 13
Disconnect the mains plug from the wall
socket ...
... if there is a fault,
... when you are not using the device,
... before you clean the device and
... during thunderstorms.
To avoid any risk, do not make modifi-
cations to the product.
FIRE HAZARD
Always place the steam brush back on
its stand and not on the sole plate, even
if you interrupt your ironing for only a
very short time. It must be placed on a
level, stable, dry and heat-resistant sur-
face. Pull out the mains plug during
longer interruptions or if you leave the
room.
DANGER! Risk of injury
through burning
Do not touch the hot surfaces of the de-
vice.
Allow the device to cool down com-
pletely before you clean it or put it
away.
Warning: risk of burns from steam and
sprayed hot water when using the
steam jet button. When using the steam
jet, always point the sole plate towards
the item of laundry or ironing board.
The sole plate becomes very hot during
operation. Only touch the handle and
control elements of the device during
operation.
Never iron or remove creases from
clothes while they are being worn.
Only transport the device when it has
cooled down.
Wait for the device to cool down before
cleaning.
Please wait until the device has cooled
down before you attach and remove the
brush attachment.
Allow the item of clothing to cool down
on a hanger before you wear it.
42 GB
WARNING! Risk of material
damage
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.
Do not iron over e.g. zips, metal buttons
or applications that could damage the
sole plate.
Never fill the water tank with chemical
substances, cleaning agents – with the
exception of limescale removers – or
other liquids. Do not use any chemically
descaled water. This may result in irrep-
arable damage to the device.

4. Items supplied

1 steam brush
1 brush attachment 17 with protective cover
1 measuring beaker 15
1 operating instructions
Please observe the illustrations on the fold-
out page.
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
3. Remove any stickers or films from the
device.
4. Remove the protective cover from the
brush attachment 17.
5. Before using for the
first time
NOTE: you may notice an odour when us-
ing for the first time. This is a result of the
manufacturing process and is not a defect
with the device. Ensure adequate ventila-
tion.
1. Ensure that you have pulled out the
mains plug 10.