Trilux HFS Serie Manual De Instrucciones Y De Instalación página 24

Teach-IN
Twilight setting via the save button/teach mode.
This button should be pressed upon desired light conditions below
which the sensor should respond in the future to movement.
The momentary twilight value is saved.
Teach-ALL (DALI version only)
send
Individual brightness value measurement for each master luminaire
all
is implemented by successive pressing of the "Teach" + "send last"
buttons.
Test mode
The test mode is for checking functionality and the detection range.
install
The luminaire switches on for 8 seconds with movement independent of
brightness. Test mode has priority over all other settings.
Test mode is automatically exited after 10 minutes without a button
being pressed, or with renewed pressing of the "install" button.
Continuous light ON/OFF
The button toggles between activation of 4-hour continuous light
4 h
(feedback LED flashes x4) and activation of normal mode (feedback
on/off
LED flashes x2).
Basic brightness (DALI version only)
(factory setting: day and night)
Basic brightness 10 minutes
10
Follow-up light after main light.
min
Basic brightness throughout the night
Basic brightness day and night
Basic brightness level/main light level (DALI version only)
LOW/HIGH
(Factory setting: 0% basic light, 100% main light)
LEVEL
The set values enable illumination with 0-50 % (basic light) and
set %
50-100 % (main light).
level
The light is switched to the selected settings for the set time (see delay
time) only with movement in the detection range.
(upper value = basic light level, lower value = main light level).
0 %
50 % Press to select the required level for basic brightness. To set the main
light, press "set level" and the button with the desired value.
The last implemented setting always applies.
24