General Information; Preparation; Placing/Application; Water Supply - Ecolab XP Foamer Manual De Servicio

4. General information

For safety reasons it is important to read this manual be-
fore mounting this equipment. In addition, the legislation
in force at the time of purchase must always be consid-
ered in connection with the installation and mounting of
this equipment, no matter the contents of this manual.
If there are matters of dispute please contact your deal-
er. This equipment is produced and tested by specially
qualified personnel, following approved instructions to
ensure our high level of product quality. After the prod-
uct is finished and tested it is manually inspected with
the ultimate test carried out just before the product is
released for shipping. To obtain our high level of quality
and long life we use stainless steel parts. These parts,
in defiance of our manual inspections may still have
some sharp edges, which can present a cut hazard.
Therefore it is advised always to use protective gloves
and show caution when installing the equipment.
The unit is UL/CSA listed.

5. Preparation

Wall version:
Identify what type of wall the unit will be mounted on.
The installation procedure for the most common wall
types is described in the installation guide.
Make sure that the walls carrying capacity is sufficient.
Mobile version:
Identify a suitable place for the unit within the reach of
the inlet hose.
Make sure the floor is level.
Note:
The pipeline must be rinsed through before
the system is connected.
Note:
Remove cover before the system is mount-
ed on the wall.
Note:
The weight of the unit is listed in the specifi-
cation section.

6. Placing/application

•
Do not use the unit outdoors.
•
The unit must be placed in frost-free rooms only.
•
The free space around the unit should be as much
as possible to make operation of the unit as easy as
possible.
• Max. ambient temp. 104°F- 40°C.
•
Non vibrating surface.

7. Water supply

Min. Pressure 29 PSI@5 gal/min -
Max. Pressure
Max. Temperature
The supply line must be sized so that it can supply the
minimum indicated pressure and water volume when
connected to this equipment.
When dimensioning the water supply, it is recommended
to increase the available volume with 15-20 % compared
to the minimum requirements listed in the table.
Note:
Recomented water hardness
100 - 129 PPM / 14 - 18 °dH.
The equipment will operate with water hardness ex-
ceeding this level. However, descaling of pump system,
injectors and like must be expected depending on use
pattern and water quality. Futhermore, wear of the me-
chanical parts will increase as well. If not supplied, filter
should be mounted.
Note:
Descaling frequency see section 15.

8. Air supply

The unit is equipped with an internal compressor.

9. Power supply

The power installation must allways be in accordance
with local legislation regardless what this manual
says.
The 60 HZ version is equipped with a GFCI plug that
must be connected to an power outlet.
0,2 MPa@20l/min
72 PSI - 0,5 MPa
158°F - 70 C
o
9