Erreka EP1-008 Manual De Instrucciones página 21

Garage light contact
LIGHT GARAGE
LIGHT GARAGE
Connect the garage light timer to the corresponding terminals (Never connect the lights
directly to these terminals).
When starting the manoeuvre, the control set will give a voltage free impulse during 3
seconds, to activate the lights-on timer.
24 V AC terminals
24 VAC
24 VAC
The control set has two terminals with a permanent output of 24V alternating current for
the power supply of peripherals, such as photocells, receivers, etc.
REVOLUTION 2 CLOSURE
REVOLUTION 1 OPEN
COMMON
3 2 1
Motor terminals
These terminals allow the connection of single-phase motors with capacitor.
The direction of rotation has to coincide with the one of the control set.
230 VAC
The capacitor is connected to the direction of rotation terminals (2 and 3).
230 VAC
Power supply terminals
You have to connect the control set to the electrical grid by using the corresponding
terminals.
It is very important that the supply is as stable as possible to avoid failures on incorrect
22