Mechanism Of Action; Explanation Of Warning Symbols; General Safety Instructions - Ottobock 50R300 Dyneva Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25

3.4 Mechanism of Action

The three-point principle and the spring mechanism result in an effective and statistically signifi­
cant reduction of the muscle-force-induced compression of the movement segments and the
small vertebral joints in the lumbar spine. Spine deformation occurs in both the sagittal and the
frontal planes. This applies for moderate as well as maximum loads. The brace effectively, signifi­
cantly and systematically reduces the load on the lumbar spine.
4 Safety

4.1 Explanation of warning symbols

Warning regarding possible risks of accident or injury.
CAUTION
NOTICE
Warning regarding possible technical damage.

4.2 General safety instructions

CAUTION
Contact with heat, embers or fire
Risk of injury (such as burns) and risk of product damage.
Keep the product away from open flames, embers and other sources of heat.
CAUTION
Excessive strain on load-bearing components
Injuries due to changes in or loss of functionality
Only use the product for the defined area of application.
If the product has been exposed to extreme strain (e.g. due to falling), take any necessary
measures (e.g. repair, replacement, inspection by the manufacturer's customer service,
etc.).
CAUTION
Reuse on other persons and improper cleaning
Skin irritation, formation of eczema or infections due to contamination with germs
The product may be used by one person only.
Clean the product regularly.
NOTICE
Contact with ointments, lotions, or other products that contain oils or acids
Insufficient stabilization due to loss of material functionality
Do not expose the product to ointments, lotions, or other products that contain oils or acids.
NOTICE
Exposure of the product to unsuitable environmental conditions
Damage, brittleness or destruction due to improper handling
Avoid storage in condensing ambient humidity.
Avoid contact with abrasive substances (e.g. sand, dust).
Do not expose the product to temperatures below -10 °C (14 °F) or above +50 °C (122 °F)
(e.g. sauna, excessive sunlight, drying on a radiator).
12 | Ottobock

Publicidad

Tabla de contenido
loading

Tabla de contenido