Peg-Perego book cross Instrucciones De Uso página 16

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ WARNING: Keep these instructions for future
reference. Read and keep them for safety use.
The child's safety could be at risk if these
instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This product is approved for children from birth up to
a weight of 15 kg in the seat.
_ For new born babies is recommended to use the
backrest in the most reclined position.
_ The Book Cross is designed to be used with
Ganciomatic Peg-Perego products: Book Cross +
"Primo Viaggio SL" (group 0+) car seat, suitable for
children from birth to 13 kg; Book Cross + "Navetta
Pop-Up / Navetta XL / Navetta Elite" suitable for babies
from birth to 9 kg.
_ When used in combination with pram body: this
product is suitable for a child who cannot sit up by
itself, roll over and a cannot push itself up on it's hands
and knees. Maximum weight of the child : 9 Kg.
Don't apply and don't use any different mattress of
that specified by the Manufacturer in the Instruction
Manual of pram body.
Any carrying handle (if present) shall be left out of the
pram body during use.
_ When used in combination with car seat (0+ group ),
this vehicle does not replace a cot or a bed.
Should your child need to sleep, then it should be
placed in a suitable pram body, cot or bed.
_ WARNING Check that the pram body or seat unit or car
seat attachment devices are correctly engaged before
use.
Check that the Peg Perego Ganciomatic product are
correctly fixed to the item.
_ WARNING The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system. Always use
the five point harness. Always use the harness crotch
strap in combination with the waist strap.
_ WARNING Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_ WARNING To avoid injury ensure that your child is kept
away when unfolding and folding this product.
_ WARNING This product is not a toy. Do not let your
child play with this product
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support
the child's weight. It is not designed to keep the child
in the seat and does not substitute for the waist belt.
_ Do not load the baskets over 5Kg. Do not put weight in
the cup holder (if present) in excess of those indicated
on the cup holders themselves and never hot drinks.
Do not put loads of more than 0.2 Kg in the hood
pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING Don't use the rain cover (if present) on a
product without a hood or parasol that can hold it.
Always use the rain cover only under adult supervision.
Don't use the rain cover indoors and check to ensure
the child is not to warm; do not park the vehicle close
to heat sources and keep well away from the lighted
cigarettes. Ensure that the rain cover is not interfering
with any moving parts of the carriage/stroller. Always
remove the rain cover before folding your carriage/
stroller.
_ WARNING: This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING Do not add any mattress are not approved
by the manufacturer.
_ Do not use accessories which are not approved by the
manufacturer.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1 OPENING: Before opening the frame, remove (without using
blades) any die-cut cardboard.
WARNING:
_ DO NOT PULL OR FORCE THE FASTENER BEYOND ITS
LIMIT.
_ DO NOT USE THE FASTENER AS A CARRY HANDLE OR
TO CARRY WEIGHTS.
DO NOT HANG BAGS OR OTHER ACCESSORIES TO THIS
FEATURE.
Press down the side fastener, hold the upper section of
the handle and rotate it towards you until the frame is fully
opened (fig_a). Open frame (fig_b).
The frame is properly opened when the attachment on the
base clicks into place, as shown.
2 FITTING THE WHEELS: then push the rear wheels on
and make sure that they click into place (fig_a). To
mount the front wheels, fit them into the uprights until they
lock into place (fig_b).
3 ATTACHING THE MAIN HANDLE: if the handle tube
faces upwards, align it with the stroller (fig_a).
Fasten the handle to the frame as shown in the figure
(fig_b).
To complete the operation, press the two side buttons
on the handle (fig_c) to ensure the handle pushes in all
the way, until it clicks into place (fig_d).
4 FITTING THE BASKET: if lowered, lift the basket tube to the
horizontal position. Press the silver buttons under the metal
basket tube located at the back of the stroller (fig_a) and
remove the metal tube (fig_b). Thread the tube through the
fabric loop on the back of the basket, making sure that the
two silver buttons are facing downward (fig_c). Re-attach
the tube to the housings (fig_d).
5 Secure the two upper basket vinyl eyelets to the two grey
buttons on either side of the metal tube housing. Please
note that the eyelets open (fig_e).
WARNING! Fasten the three lower basket loops to the
three grey buttons on the rear bar (fig_f).
WARNING! If this operation is not completed properly,
the basket will not support any weight.
Fasten the front basket flaps to the grey buttons on
the frame (fig_g) and then secure the basket centrally
to the footrest using the Velcro strap (fig_h).
6 HOOD: Fasten the hood at the back using the Velcro
strip (fig_a), insert the hood attachments into their
slots (fig_b), secure with the external rubber band to
the buttons on the inside of the handlebar (fig_c), and
finally button the hood laterally to the frame (fig_d).
7 FIXED OR SWIVEL FRONT WHEELS: to fix the front
wheels, rotate the lever counter clockwise to the
locked padlock (fig_a); to release the wheels, turn the
lever clockwise to the unlocked padlock (fig_b). On
- 16 -