Mounting Input/Output Module(S) - Aventics INTERBUS S Instrucciones De Servicio

96 AVENTICS | INTERBUS S | R412005743–BDL–001–AD
Disassembly and Exchange
7. Make all the presettings on the new bus coupler (4) (see
"Making presettings" on page 80).
8. Reestablish the connections.
9. Check the configuration and adjust it if necessary.
8.2

Mounting input/output module(s)

Observe the following when adding an input/output module to
the valve system:
Applied voltage and high pressure!
Danger of injury from electric shocks and sudden pressure
drops.
Make sure that the system is not under voltage or
O
pressure.
Open inputs/outputs
Danger of electric shocks caused by contact, short circuits, or
damage to the system.
Always close unused inputs or outputs with M12 and M8
O
protective caps (see accessories) to comply with the IP65
protection class.
CAUTION
CAUTION