Rapid 100E Manual Para El Usuario página 38

aCCESSorIES
As extra equipment there is a pedal available for foot manoeuvring the
machine.
The pedal must be fitted permanently and by authorised personnel.
InStallatIon
The Rapid 100E is installed as follows:
1 Position the machine on a stable horizontal surface that is smooth and
clean so that the suction pads on the feet affix themselves to the surface.
2 Check that the machine is suitable for the electrical power supply
available (voltage and frequency) by reading the data on the rating plate.
3 Insert the machine's plug into the electric socket.
opEratIon
filling staples
Fill the machine with staples when required as shown in figure 3:
1 Turn off the switch on the machine.
2 Lift up the visor.
3 Open the magazine by pressing down the lock. Pull out the magazine.
4 Put the staples into the magazine as shown in the figure. Use the type of
staple stated on the magazine. Use only Rapid original staples.
Interruptions in operation can be caused by use of the wrong type
of staple.
5 Close the magazine so that it locks in the closed position.
adjusting the trigger position
The distance between the staple and the edge of the stapling object is
determined by adjusting the position of the trigger as follows. See figure 4:
1 Turn off the switch on the machine.
2 Lift up the visor.
3 Adjust the trigger position (M) by lightly squeezing the rider above the
graduated scale (N) and then move the trigger along the hexagonal rod.
4 The distance between the staple and the edge of paper can be read on
the graduated scale.
pinning
Select pinning or normal stapling as follows. See figure 5:
1 Turn off the switch on the machine.
2 Lift up the visor.
3 Move the anvil to the rear position for pinning, or to the front position for
normal stapling.
gb
33