Makita EM2653LH Manual De Instrucciones página 10

Installing the protector (cutting tool guard)
WARNING:
Always use the tool with the approved combination of the safety equipments. Otherwise contact with a cutting tool may cause serious injury.
CAUTION:
Tighten the right and left bolts evenly so that the gap between the clamp and the protector is constant. Otherwise the protector may not function
as expected.
To meet the applicable safety provisions, only the tool / protector combinations as indicated in the table must be used.
Use of metal blade
Metal blade
Use of nylon cutting head
Nylon cutting head
For metal blade
Fix the protector type A (1) to the clamp (2) with two bolts M6 x 25 (3) with hex
wrench 5 (4).
Clamp washer, cup,
and nut are necessary
Type A
Type A
Protector Use with barrier
Protector
Type B
10
Use with shoulder harness
Type C
3
4
1
2