Makita EM2653LH Manual De Instrucciones página 9

ASSEMBLY
CAUTION: Before doing any work on the Petrol Brushcutter, always stop the
engine and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the Petrol Brushcutter only after having assembled it
completely.
Hex wrench storage
When not in use, store the hex wrench 4 to keep it from being lost.
Adjusting the handle position
Loosen the bolt, and adjust the position of the handle.
After deciding the position, tighten the bolt.
Make sure the handle locates between the arrow mark and the spacer.
WARNING:
Do not remove or shrink the spacer. The spacer keeps a certain distance
between both hands. Setting the handle close to the other
grip beyond the length of the spacer may cause loss of control and
serious personal injury.
Removing or installing the barrier (optional accessory)
WARNING:
When using the brushcutter with the metal blade, always install the barrier.
To install the barrier, align the barrier with the handle and tighten them with the
screw.
To remove the barrier, loosen the screw and remove the barrier.
9