Allmatic KALOS XL Serie Manual Del Usuario página 11

To fix the motor to the counterplate, insert and screw the two Allen screws into the appropriate housing (Fig. 5). Position the motor in parallel with the
gate and with the gear under the rack as shown in Fig. 8.
N.B. It is important to energetically tighten the two screws, making sure that the gearmotor is firmly on the ground during the entire stroke of the gate.
GRANTS FIXING FOR THE ADJUSTMENT OF THE PLANARITY OF THE GEARMOTOR
If the adjustment permitted by the rack is not sufficient, it is possible to compensate the height of the gearmotor by acting on the four adjustment
screws, as shown in Fig. 6.
RACK FITTING
The rack must be fixed at a certain height with respect to the motor fixing plate (Fig. 3). This height can be changed thanks to the slots on the rack.
The height adjustment is made so that the gate doesn't rest on the motor gear drive (Fig. 7) during movement. To fix the rack on the gate, make
holes of Ø 5 mm and thread them using a male of the M6 type. The drive gear must be approximately 1 mm to 2 mm away from the rack (Fig. 7).
GEARMOTOR POSITIONING IN RELATION TO THE GATE
WARNING! Position the motor with the pinion under the rack as shown in figure 8.
WARNING ! The distance between the motor and the gate must be constant throughout the stroke.
6-1624804 rev.7
1mm...2mm
NO
20/01/2020
Fig. 7
OK
Fig. 8
Fig. 6
11 / 32