Allmatic KALOS XL Serie Manual Del Usuario página 13

ATTENTION! If magnetic limit switches are used, configure the parameters on the control unit as indicated below:
Gearmotor
Gearmotor code
Control Unit
Amplitude of slowdown
Slowdowns speed
Slowing down mode
GATE POSITIONING IN RELATION TO SURFACE
For special installations request information from Allmatic or use larger geared motors.
RELEASE
To move the gate manually it is necessary to release the gearmotor inserting the key, turning it for 90° and open the lever (Fig. 14).
In order to carry out the manual operation of the gate leaf the followings must be checked:
- That the gate is endowed with appropriate handles;
- That these appropriate handles are placed so to avoid safety risks for the gearmotor;
- That the physical effort necessary to move the gate leaf should not be higher than 225 N, for doors/gates for private dwellings, and, 390N for doors/
gates for commercial and industrial sites ( values indicated in 5.3.5 of the EN 12453 norm).
DISPOSAL OF THE PRODUCT
This product is an integral part of the automation, and therefore, they must be disposed of together. As for the installation operations, at the end of the life
of this product, the dismantling operations must be performed by qualified personnel. This product is made from different types of materials: some can be
recycled, others must be disposed of. Please inform yourselves on the recycling or disposal systems provided for by the laws in force in your area, for this
category of product.
CAUTION! – some parts of the product can contain polluting or dangerous substances which, if dispersed in the environment, may cause serious harm to the
environment and human health.
As indicated by the symbol at the side, it is forbidden to throw this product into domestic refuse. Therefore, follow the "separated collection" instructions
for disposal, according to the methods provided for by local regulations in force, or redeliver the product to the retailer at the moment of purchase of
a new, equivalent product.
CAUTION! – the regulations in force at local level may envisage heavy sanctions in case of abusive disposal of this product.
WARRANTY
In compliance with legislation, the manufacturer's guarantee is valid from the date stamped on the product and is restricted to the repair or free
replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or manufacturing defects. The guarantee does
not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect product, assembly
errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired. Printed specifications
are only indicative. The manufacturer does not accept any responsibility for range reductions or malfunctions caused by environmental interference. The
manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our defective products, are only those
responsibilities that come under Italian law.
6-1624804 rev.7
KALOS XL
230V 800KG
12007882
BIOS1 230V
≥
LSI 30
-
SpL -
SsL = 0
Fig. 13
OK
20/01/2020
KALOS XL
230V 1200KG-1500KG
12007881-12007859
BIOS1 230V
≥
30
-
-
= 0
KALOS XL KALOS XL
24V 1000KG 24V 600KG FAST
12007886 12007877
BIOS1 24V BIOS1 24V
≥ ≥
30
≤ ≤
40
- - -
NO
30
20
-
Fig. 13
Fig. 14
13 / 32