Lincar Lola Manual Del Usuario página 59

The appliance continues working at the minimum, if at the minimum power, one of the
selected temperatures (room or boiler) is exceeded by some degrees, starts the cycle of
extinction and at the end of this cycle the display signals "STAND-BY".
MENU 05 (status buzzer)
Within this Menu you can select the modality of buzzer.
OFF, no sounds.
ON ALWAYS, sound in case of alarm
MENU 06 (load initial)
Within this Menu you can set the continuous fuel load, this operation can only be effected
when the appliance on the display is evidencing "OFF". This menu is utilized to fill the screw
feeder when the appliance is new or in case of emptying of the pellet container.
MENU 07 (status appliance)
Within this Menu you can find some informations about the working of the appliance.
MENU 08 (pellet correct)
Sometimes, changing type of pellet, there are so many types of wood pellet on the market, the
combustion of the appliance can be affected. A clear signal of an inefficient combustion is
given by the quantity of pellets into the burner basket during the normal working phase: too
much or too scarce. It is possible to make some small regulations on the combustion of the
appliance. Under the assumption that during the working phase the burner basket should be
full of pellet from ¼ to half of its capacity, whenever necessary, you can make some
adjustments following the below procedures:
a- Observe the appliance and verify if the pellet is piling up till to the complete filling
of the basket or if the basket is emptying itself almost till to the extinction of the
fire.
b- Push on button P3 to enter into the Menu.
c- Run on the Menu utilizing the buttons P5 and P6 until you arrive to MENU 08
d- Push again on button P3 to accede to MENU 08.
e- An Access Key is requested, utilizing the button P1 or P2 run on the number in the
upper part of the screen until you arrive to number 33.
f- Push again on button P3 to confirm the Access Key and to enter into the modality of
combustion modification.
g- Use buttons P1 and P2 to modify the number shown on the display on the upper
part, as indicated in the below table; to increase the quantity of pellet you must
increase the value, to decrease the quantity of pellet, decrease the value.
ATTENTION! We recommend to modify the value increasing/decreasing by only
one number per time. Verify the working of the appliance for one or two days, after
having cleaned the burner basket, only after this period of verification eventually
make a new regulation.
h- Terminate the regulation of the carburetion pressing shortly on button P4.
increase pellets
9 8 7 6 5
MENU 9 (technical settings)
RESERVED TO TECHNICIANS.
4 3 2 1 0
59/140
IT-GB-FR-ES mod. 540 – 540N
decrease pellets
-1 -2 -3 -4 -5 -6 -7 -8 -9