Safety Instructions / Maintenance - Eneo VMC-5.6/2-LCD Instrucciones De Montaje Y Servicio

1. Safety Instructions / Maintenance

• Read these safety instructions and the operation manual first before you connect and power to the unit.
• Keep the operation manual at a safe place for later reference.
• The monitor generates only little heat. However, care has to be taken that the warm air can get out and fresh air gets in.
• Never cover the ventilation slots to avoid overheating.
• Keep sufficient distance to other units to ensure air circulation. Overheating shortens the life time of the unit and
could set it on fire in worst case.
• If the unit is placed in closed racks it is mandatory to keep sufficient distances.
• If the monitor is brought to a warm room from a cold place allow it to warm up before you power it on.
• Protect unit and cables from entry of moisture and humidity. Never power the unit up if humidity entered but have
it checked at a qualified service station. Contamination of humidity can destroy the unit and lead to an electrical
shock.
• Operate the unit only at a temperature range of 0°C to +50°C and a humidity of max. 90%.
• Never place the monitor in direct sunlight or close to a window. Humidity and direct sunlight can cause substantial
damage.
• Never insert metallic or other parts into the ventilation slots. This could cause permanent damage to the unit.
• Do not place any heavy objects on the unit.
• Never apply pressure to the LCD screen. This could cause permanent damage to the display.
• Always disconnect the unit from mains if it has to cleaned or is not used for a longer time. Unplug the cable from
the wall outlet in this case, not at the monitor.
• P ay attention when laying the connection cable and observe that the cable is not subject to heavy loads, kinks, or
damage and no moisture can get in.
• Make sure that the connection cables are not stressed, bent or damaged during the installation.
• Contact your local dealer in case of malfunction.
• The warranty becomes void if repairs are undertaken by unauthorized persons. Do not open the housing.
• Maintenance and repair have to be carried out only by authorized service centers.
Before opening the cover disconnect the unit from mains input.
• Only use original parts and accessories from Videor E. Hartig GmbH.
• D o not use strong or abrasive detergents when cleaning the dome. Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
• The user of this system has to adhere to local regulations on surveillance, recording and interception of audio
signals. This is his sole responsibility to keep himself informed on these regulations.
NOTES regarding burn-in effect on TFT monitors
• Normally, an image cannot be „burned" onto an LCD screen, as is the case with tubelar monitors.
• However, a „memory effect" can occur, which generally becomes visible after the same image has been displayed
for several hours. With fixed images the liquid crystal molecules are arranged in a certain way and can eventually
become so inert that they no longer completely renew themselves.
• If an „after image" occurs, the resulting white images can be corrected using a generator.
• The memory effect should not be regarded as a fault; rather it is inherent in the LCD Panel structure and method of
working. A warranty claim cannot be brought on the basis of the memory effect. More details on request.
8