Safety Devices; Safety And Information Signs - Angelo Po 0G0FR5Gl 1G0FR6G Manual De Uso E Instalación

SAFETY DEVICES

Although the appliance is complete with all safety
devices, during installation and connection addi-
tional devices must be added if necessary to com-
ply with the relevant legal requirements.
The illustration shows the position of the devices.
A)Gas supply tap: for turning the connection to the
gas supply line on and off.
B)Safety thermocouple: cuts out the gas supply if the
flame goes out
C)Safety thermostat: cuts off the gas supply in case of
overheating
Caution - warning
Make a daily check that the safety devices are
properly installed and in good working order.

SAFETY AND INFORMATION SIGNS

The illustration shows the position of the signs fitted
on the appliance.
A)Nameplate with manufacturer and appliance
data
B)General hazard: read the manual carefully be-
fore carrying out any procedure.
C)General hazard: when washing the appliance do
not point pressurised water jets at internal parts.
D)General hazard: all relevant regulations must be
complied with. "Install in compliance with the rel-
evant regulations and use in well ventilated
premises only".
E)General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of
failure to comply with the installation and com-
missioning instructions".
F) Burn hazard: watch out for hot surfaces.
G)CE marking: indicates that the equipment is
compliant with all relevant laws applicable to the
product.
C
B
C
A
- 5 -
A
IDM-39618900300.tif
F
D
E
G
C
IDM-39618900400.tif
IT
GB
DE
FR
ES
B
English