BH G290 Instrucciones De Montaje página 17

2.- ATTACHING THE
HANDLEBAR STEM.-
Take the handlebar
packaged in with the main body (1)
and insert it into the handlebar post
(18) in the direction of the arrow,
Fig.2. Tighten knob (79) by turning it
clockwise and fit the end cover (20),
securing it by using screws (21).
Next, insert the handlebar post into
the boss on the main body (1) as
shown in Fig.2.
Position it for average height and
tighten by turning the retaining knob
(79) clockwise, Fig.2.
3. FITTING THE STABILISER
BARS.-
Take the rear stabiliser bar with
adjustable feet (4), Fig.3, insert the
bolts (78); fit the washers (77) and the
nuts (76) and tighten securely.
Bring the front stabiliser bar with
wheels (3) to the main body (1)
positioning the wheels at the front of
the unit, Fig.3, insert screws (78), fit the
corrugated washers (77) and the nuts
(76). Use the key to tighten securely.
4. FITTING THE FOCUS BAR
SPINDLE.-
Insert the focus bar spindle (23)
through the horizontal support on the
main post, Fig.4, leaving it centred
between the two lines (B) marked on
the spindle. Tighten screws (67)
securely.
5. FITTING THE FEET.-
Take the right foot (7R) and fit the
bush for the focus bar (17) onto the
spindle (23) Fig.5.
Next, insert the connecting rod (R)
onto the square shaft (30), Fig.5, and
use
connecting rod securely.
Take screw (13), along with washer
stem (2)
(14) and tighten it securely onto the
spindle (23), Fig.5.
ATTENTION: Take the left foot (7L)
and perform the same assembly
procedure as with the right foot (7R),
making sure that the left connecting
rod (L) is at 180 degrees with respect
to the right connecting rod, as shown
in Fig.5A.
Fit the bottle holder (34) onto the
handlebar post support on the main
body (1) using screws (66), Fig.5A.
WARNING:
It is important to retighten all of the
screws involved in assembling the
machine after a few hours of use,
paying special attention to screws (27)
for the connecting rods (R) and (L),
Fig.5A.
6. FITTING THE FOOTRESTS.-
Position the left footrest (35 marked
with the letter "L") on top of the unit's
left foot (7L), Fig.5, (left and right
refers to the user's position doing
exercise) refit the screws (43), and
tighten securely.
Next, position the right footrest (36
marked with the letter "R") on top of
the right foot (7R), refit the screws
(43), and tighten securely.
17
screw (27) to tighten the