BH G290 Instrucciones De Montaje página 19

3. Front and rear stand bracket
surfaces. Fig 13 and 14.
4. Area where the stands are
clamped to the frame. Fig 15.
5. Joint between the pedal and the
crank. Fig 16.
6. Chromed
surfaces and horizontal surfaces
where the handlebar post is
locked. Fig 17.
Application:
Shake well before using.
Hold the can 20 to 30 cm away from the
surface to be sprayed
extension tube.
Wait two minutes until the product
stabilises.
Carefully spread with a clean cloth,
leaving a light and uniform coat over the
surface, and wipe off any excess.
For areas with difficult access use a
brush to apply the product. Leave to dry
for about 3 hours.
Handling Precautions
Avoid all ignition sources (spark or
flame).
DO NOT allow the material to come in
contact with eyes or skin. Wear
appropriate protective
during handling. Keep the container
closed. Avoid breathing vapours or
mists. Use only
ventilation. Wash
contaminated clothing thoroughly after
handling.
Storage
Keep the product in a cool, well-
ventilated area. Avoid all ignition
sources (spark
between 4.4ºC and 49ºC. Store all
materials in a dry, well-ventilated area.
Avoid breathing vapours.
3.- Apply the BH indoor cycling protector
with a clean cloth to polish the product.
Application: Application should be over
the entire machine while this is dry.
Spray the BH indoor cycling protector
over the surface to be treated.
Then spread with a clean cloth. Wipe dry
with the cloth. Do not let the product self-
handlebar post
using the
equipment
with adequate
hands and
or flame). Store
dry.
Note: In case any part or component
needs to be replaced, follow the same
operations described above. Use only
original BH spare parts.
PREVENTIVE MAINTENANCE OF
THE MACHINE
Every class
1. The user must check that the
apparatus is safe and appropriate for
exercise.
2. A cloth or towel should be used to
remove sweat after the session has
ended.
Weekly
1. Thoroughly inspect each apparatus
to make sure it is in safe and proper
working order. Check screws, nuts
and bolts, handlebar, saddle, knobs,
etc.
2. Use warm water and a cloth to
clean the parts that are dirty or that
are in continuous contact with sweat.
3. If you need to use soap, use the
gentle MEGUIAR'S NXT soap, which
will not damage the paint. In this case
follow with the BH indoor cycling
protector, cleaning the area with a
clean, dry cloth. Wipe dry after.
Monthly
Tensioning the chain -
1.-
1) Loosen the safety bolt on the inertia
flywheel (69) Fig. 18.
2) Adjust the chain tension by turning
the adjustment nuts (22) anticlockwise
(on the side shown in the diagram)
and clockwise on the other side.
3) It is advisable to make a ¼ turn
each time on both sides of the
flywheel.
4) Do not turn the adjustment nuts
excessively, otherwise the chain will
19