Operating The Device Safely; Intended Use - Waeco BordBar TF-14 Instrucciones De Uso

_TF-14.book Seite 13 Mittwoch, 12. Dezember 2007 9:58 09
BordBar TF-14
Disconnect the cooling device and other power consuming de-
vices from the battery before connecting the quick charging de-
vice.
Check that the voltage specification on the type plate corre-
sponds to that of the energy supply.
2.2

Operating the device safely

Do not place any electrical devices inside the cooler.
a
Before starting the device, ensure that the power supply cable
and the plug are dry.
Do not place the device near naked flames or other heat sourc-
es (heaters, direct sunlight, gas ovens etc.)
Caution! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other ob-
jects so that the air can circulate.
Do not fill the inner container with ice or fluid.
Never immerse the device in water.
Protect the device and the cable against heat and moisture.
Do not touch exposed cables with your bare hands. This
especially applies when operating the device with an AC mains
power supply. Danger of fatal injuries!
The manufacturer cannot be held liable for damage resulting
from improper usage or incorrect operation.
3

Intended use

The cooler is suitable for cooling foodstuffs.
The device has been designed for use with a 12 V DC vehicle
electrics socket of a car (cigarette lighter), boat or caravan.
The appliance may also be used for camping use. The appliance shall not to
be exposed to rain. It can be used as a box or cupboard.
Note:
I
To operate the device using a 220-240 V AC mains supply, we
recommend using a rectifier.
Intended use
13