Reassembly For Future Use - Joovy Tricycoo UL Manual De Instrucciones

Reassembly for Future Use

When you are ready to use the product for a second child, follow the instructions below to reinstall
the components that you previously saved.
Reinstalling the Early Stage Footrests
• Orient the footrests on the appropriate side of the product and slide each one into its slot under
the seat. (54)
• Pull on them to ensure they are secure.
Reinstalling the Seatback/Canopy/Armbar Assembly
• Reach under both sides of the seat and locate the seat release buttons, one on each side.
• Hold the seat and with one finger pull these buttons out toward the side. (35)
• Lift the seat up and remove it from the product. (36)
• Using the Allen wrench, reattach seatback/canopy/armbar assembly by screwing the two bolts
at the base of the seatback into their holes in the seat. (55) Ensure they are tight but do not
overtighten.
• To reinstall the crotch strap, twist the plastic locking pin and pull it through the fabric slot to
remove it. (56)
• Push the crotch strap down through the slot at the front of the seat. (57)
• Replace the pin into the fabric slot and pull the crotch strap back up so that the locking pin fits into
the slot. (58)
• Reinstall the reassembled seat onto its base attachment, ensuring it is facing toward the front of
the product. Push down firmly until the seat securely snaps into place. (59)
• Pull up on the seat to ensure it is securely attached.
Reinstalling the Push Handle
• Remove the cap that is covering the push handle hole behind the seatback. (60)
SAVE THIS CAP FOR FUTURE USE.
• Stand behind the product and orient the push handle with the cup holder toward the rear of the
product and insert the push handle into its attachment hole. (61)
• Ensure the push handle clicks into place. You may need to twist it slightly to accomplish this.
• Pull up on the handle to ensure it is securely attached.
After replacing all these components, refer to the Operation section of the manual.
10