Operation - Joovy Tricycoo UL Manual De Instrucciones

Operation

I WARNING:
should always be used for children who are not yet capable of
sitting in the seat without support or who are unable to pedal the
product.
Rear Wheel Brakes
• To lock the rear wheel brakes, push down on the brake levers on BOTH wheels. (18)
IMPORTANT: Gently push the tricycle back and forth to ensure the brake is fully engaged.
• To unlock the brakes, pull up on BOTH brake levers. (19)
Securing a Child in the Seat
• FIRST, ensure that BOTH rear wheel brake levers are in the down position and the rear wheels are
locked.
• Open the armbar by pressing the button underneath the middle of the bar. Then spread the two
halves of the bar apart toward the sides of the product. (20)
• Press the button on the center buckle of the harness assembly to release the shoulder/waist
straps from the crotch strap. (21)
• Place your child on the seat and position their arms through both shoulder/waist straps.
• Reinsert both shoulder/waist strap connectors into the center buckle. (22)
• The shoulder and waist straps may be adjusted using the sliding plastic rings. Make sure the
shoulder straps and waist straps fit snugly around the child.
• Close the armbar by bringing the two halves back together, pressing the button in and sliding one
of the bars over this button. (23) Check to be sure the armbar is securely closed and locked.
Adjusting the Shoulder Straps
The straps can be adjusted to two heights. ALWAYS adjust BOTH straps to the SAME height.
• Push one of the shoulder straps through the slot in the seatback. (24)
• Twist the plastic locking pin and push it through the fabric slot to remove it. (25)
• Pull the strap back through the slot to remove it.
• Put the pin aside to use it for reassembly.
• Do the same for the other shoulder strap.
• Put the pin aside to use it for reassembly.
• Pull the top of the setback pad to detach it from the setback on both sides. Pull it out so that the
lower slots for the shoulder straps are exposed. (26)
• Insert each shoulder strap through the slots in the seatback pad and then through the
corresponding slots in the seatback. (27)
• Push the seatback pad onto the seatback so that ALL snaps are secured back into place. (28)
• Replace the pins into the fabric slots on the ends of both shoulder straps and pull the straps
toward the front of the product so that these pins are pulled into the slots in the back of the
seatback. (29)
Seatback Recline
• To recline the seatback, pull up on the release handle on the back of the seatback. (30)
• Move the seatback toward the rear of the product and release the handle. (31) Ensure the
seatback locks securely into the recline position.
• To put the seatback into the upright position, pull up on the release handle and move the seatback
up.
BE CAREFUL! Do not move the seatback too far forward as the child may be injured.
The Armbar and Child Restraint Harness
7