Joovy Tricycoo UL Manual De Instrucciones página 9

• Pull the crotch strap back through the slot to remove it and replace the pin into the fabric slot.
• Move the seatback into the upright position to expose the seatback attachment bolts. (46)
• Using the Allen wrench, unscrew the two bolts at the base of the seatback. (47)
• Detach the entire seatback/harness assembly from the product.
KEEP THE BOLTS IN THE HOLES ON THE SEAT BACK SO THEY DO NOT GET LOST AND
SAVE THIS ENTIRE ASSEMBLY FOR FUTURE USE.
You will need them to reinstall the seatback/harness assembly for future use.
• Reinstall the seat onto its base attachment, ensuring it is facing toward the front of the product.
• Push down firmly until the seat securely snaps into place. (48)
• Pull up on the seat to ensure it is securely attached.
Removing the Push Handle
• Stand behind the product and reach under the bottom of the push handle bracket to locate the
metal push button. (12)
• Push this button toward the front of the product while grasping and pulling the push handle
upwards out of this bracket. (13)
• Place the push handle cap into the hole where the push handle was removed. (49)
SAVE THE PUSH HANDLE FOR FUTURE USE.
Locking the Handlebar
• Orient the handlebar perpendicular to the front wheel.
• Push DOWN on the ring just at the top of the front wheel fork to lock the handlebar. (50)
• Check to ensure the handlebar turns the front wheel.
Locking the Front Wheel Pedals
• Turn the switch on the side of the front wheel COUNTERCLOCKWISE until a click is heard. (51)
• Check to ensure the pedals rotate the front wheel.
Folding the Product for Storage or Travel
• Remove the child from the product.
• Lock both rear wheel brakes.
• Fold the armbar UP to rest against the seatback.
• Close the canopy so that it is vertically in line with the seatback.
• Adjust the push handle to its LOWEST position.
• Rotate the flip-down footrests up and in.
• Pull the locking lever UP and then toward you, then DOWN to release the lock. (52)
• Grasp the carry handle at the bottom of the seatback and pull UP while at the same time pushing
DOWN on the push handle. (53)
• Pull UP on the release handle on the back of the seatback and push the seatback/canopy/armbar
assembly all the way toward the front of the product.
• Fold the canopy toward the rear of the product and down onto the seatback.
• Push in on both the left and right rear wheel frame bars to lock them in place.
• Lift and carry the product by the carry handle.
9