Joovy Tricycoo UL Manual De Instrucciones página 8

Canopy
• The canopy can be adjusted to be fully opened, fully closed or anywhere in between simply by
pulling or pushing the front of the canopy into the desired position. (32)
Unlocking the Front Wheel Pedals
• These pedals should be in their UNLOCKED position. Check by rotating the pedals and if the front
wheel also rotates, the pedals must be switched to the UNLOCKED position.
• Turn the switch on the side of the front wheel CLOCKWISE until a click is heard. (33)
• Check to ensure that the front wheel does not rotate when pedals are rotated.
Handlebar
• The handlebar should be in the UNLOCKED position. Check by turning the handlebar and if the
front wheel turns, the handlebar must be switched to the UNLOCKED position.
• Pull UP on the ring just at the top of the front wheel fork to unlock the handlebar. (34)
Reversing the Seat Direction
The seat can be reversed to have your child facing toward you.
• Reach under both sides of the seat and locate the seat release buttons, one on each side.
• Hold the seat and with one finger pull these buttons out toward the side. (35)
• Lift the seat up and remove it from the product. (36)
• Turn the seat around 180° to face toward the rear of the product and replace the seat onto its base
attachment. Push down firmly until the seat securely snaps into place. (37)
• Pull up on the seat to ensure it is securely attached.
Flip-Down Footrests
When your child is old enough, you can detach the early stage footrests and use the flip-down footrests.
• Reach under the seat where the early stage footrests are attached and press the release button. (38)
• Then just slide the early stage footrest out of the slot. (39)
SAVE THESE TWO EARLY STAGE FOOTRESTS FOR FUTURE USE.
• Rotate the flip-down footrests down and outward. (40)
Removing the Canopy
• To remove the canopy, pull the connecting tab on each side of the canopy horizontally out of its
slot on the seatback. (41)
SAVE THE CANOPY FOR FUTURE USE.
Removing the Armbar
Once your child is a little older, they may not need the armbar.
• Open the armbar by pressing the button underneath the middle of the bar. Then spread the two
halves of the bar apart toward the sides of the product. (20)
• Rotate each half of the armbar UPWARD 90° and then pull them outward from the product. (42
and 43)
• Reconnect the two halves of the armbar.
SAVE THE ARMBAR FOR FUTURE USE.
Removing the Seatback/Harness Assembly
• Reach under both sides of the seat and locate the seat release buttons, one on each side.
• Hold the seat and with one finger pull these buttons out toward the side. (35)
• Lift the seat up and remove it from the product. (36)
• Push the crotch strap up through the slot in the plastic seat. (44)
• Twist the plastic locking pin and push it through the fabric slot to remove it. (45)
8