Fermax 5276 Manual De Usuario página 12

Cod. 97864 V04_17
When Use NO/NC/COM Dry Contact Output
with lock's supply voltage, or else, the
lock will not work properly or be damaged.
INSTALACIÓN
Wiring
Name
The Left Side
LED Green LED Light Control
D1 Wiegand Input Data 1
D0 Wiegand Input Data 0
GND Negative Pole of DC (9~24V) Power Input
+DC Positive Pole of DC (9~24V) Power Input
The Right Side
OPEN Connect to One Wire of Exit Button
NO Normally Open Relay Output (install diode provided)
GND Negative Pole of Lock
(COM) (Common Connection for Relay Output)
NC Normally Closed Relay Output (Install diode provided)
Diode IN4004 (For relay circuit protection)
Self Tapping Screws: Φ3*25mm
Wall Anchors
Screw Driver
*
1) Remove the Pin Caps on points 1, 2 and
points 3, 4
2) Insert one of the Pin Caps on points 1, 3
3) Fix the back cover, and keep the other Pin
Cap well
Remark:
The power supply's voltage must be the same
Notes
12