Programming - Fermax 5276 Manual De Usuario

Cod. 97864 V04_17
Installation
Door/Gate Operator or Fail-secure Lock
Reset to Factory Default and Master Cards Programming
To reset to factory default, power off, press the Exit Button (or connect "OPEN" and "GND"
to be short circuit), hold it and power on, there will be two beeps, and the LED light turns into orange, release the exit
button (or disconnect "OPEN" and "GND"), then read any two cards on the external reader, the LED will turn into red,
means reset to factory default successfully. Of the two cards reading, the 1 one is Master Add Card, the 2 one is the
Master Delete Card.
Remarks:
① The Master Cards are not included in the standard packing. The type of the Master Cards is according to the external
reader. For example: the external reader is 125KHz HID Reader, then the Master Cards must be 125KHz HID cards.
② If no Master Cards added, must press the Exit Button for at least 10 seconds before release.
③ Reset to factory default, the user's information is still retained.

Programming

Programming will vary depending on access confirguration. Follow the instructions according to your access
configuration.
Notes:
Remote Control: Please use the Infrared Remote Control to program the Sboard. The
"IR" on the Sboard is the infrared receiving window, please direct the Remote Control to
it.
User ID number: Assign a user ID to the access card in order to track it. The common
user ID number can be any number fom 0~999. IMPORTANT: User IDs do not have to be proceeded with any
leading zeros. Recording of User ID is crical. Modifications to the
user require the User ID be available.
PIN: Can be any 4~6 digits except 8888 which is reserved.
For the users: after entering the code confirm with dash (Eg: 9876#)
13