Fermax 5276 Manual De Usuario página 14

Cod. 97864 V04_17
Enter and Exit Program mode
Programming Step
1. Enter Program Mode
2. Exit Program Mode
Set Master Code
Programming Step
1. Enter Program Mode
2. Update Master Code
3. Exit Program Mode
Add Users with Remote Control
Sboard Connected with Card Reader:
For the readers develop together with Sboard, such as S series readers, skip the below
step 1; For other card readers, set the Sboard's Wiegand input as below step 1 according to the Wiegand output of the
readers.
Sboard Connected with Keypad Reader:
Can be any Keypad Reader with 4Bits, 8Bits (ASCII), 10Bits output format
Set the Sboard as below step 1 according to the Wiegand output and PIN output format of the Keypad Reader.
PIN(s) can be input/added on either the remote control or the external Keypad Reader,
except when the Keypad Reader is 10 digits virtual card number output, the PIN(s) can
only be input/added through the Keypad Reader.
Step 1
Programming Step
1. Enter Program Mode
2. Wiegand Input bits
PIN Input bits
3. Exit Program Mode
Remarks: 4 means 4 bits, 8 means 8 bits, 10 means 10 digits virtual number.
Keystroke Combination
* (Master Code) #
(Factory default is 123456
*
Keystroke Combination
* (Master Code) #
0（New Master Code）#（Repeat New
Master Code）# (code: 6 digits)
*
Keystroke Combination
* (Master Code) #
(Factory default is 26bits)
8 (26~37) #
8 (4 or 8 or 10) # (Factory default is 4bits)
*
14