Control Panel Menu - Lincar Lola Manual Del Usuario

CONTROL PANEL MENU

-Push on button P3 to have access to the menu
-Use buttons P5 and P6 to run on the different menu
-Push again on button P3 to enter into the displayed menu
-Use buttons P5 and P6 to run on the different submenu, the buttons P1 and P2 modify
the value shown on the display
-The button P3 accedes to the displayed menu/submenu
-The button P4 returns always to the previous menu
MENU
Menu 01 FAN REGULATION
•
Menu 02 SET WATCH (Setting the clock inside the equipment).
•
Menu 03 SET CHRONO (Set schedules for automatic on / off).
•
Menu 04 CHOSE LANGUAGE (Program the language of control panel).
•
Menu 05 STAND-BY (On/Off Stand-By)
•
Menu 06 SOUND (Setting the beep sound).
•
Menu 07 FIRST LOADING (On the loading pellet in continuous ).
•
Menu 08 STOVE STATUS ( To visual the equipment status).
•
Menu 09 CORRECT PELLETS (Correction of equipment carburation).
•
Menu 10 TECHNICAL CALIBRATIONS (Only for TECHNICAL STAFF).
•
This equipment is supplied by fans for entering of hot air into the rooms :
FAN1 in the frontal part
•
FAN2 it's not present and it's not available for this model.
•
MENU 01 (fan regulation)
Using this menu is possible to set the modality of functioning of Ventilation1 air convection.
Use the button 1 to modify the setting.
It's possible 2 types of programs that will be :
A – The set up ventilation will adapt automatically to equipment power.
1....5 – The ventilation selected will function always to selected power. (since 1 to 5)
On display appears also the Vent2 : this is not to take into consideration because it's not
present and it's not available for this model.
MENU 02 (set clock)
With this Menu you can adjust the time and the date of the electronic card, the set date and
time will be utilized as reference for the activation of the switch ON/OFF programs
Keep ATTENTION to the regulation of Time and Date, these regulations influence the on/off
programs for the automatic lighting and turning off.
MENU 03 (set chrono)
Within this Menu you can set up the automatic cycles of switching ON/OFF you desire to
utilize. There are 3 different modalities you can use, even contemporaneously, but pay
attention to not overlap the programs.
IT IT IT IT- - - - GB GB- - - - FR FR- - - - ES
GB GB FR FR
58/140
ES mod. 540 VT – 540N VT
ES ES