Setting Time And Date - ProMed MTX Instrucciones De Manejo

blood pressure monitor is no longer being used, first remove the connector from the blood
pressure monitor and then pull the mains adaptor out of the mains socket. Doing this
means that the date and time will not have to be reset each time.

3.3 Setting time and date

Your promed MTX blood pressure meter is equipped with a radio clock controlled
by the DCF77 signal. This automatically sets the time and date. If there is no DCF77
signal within range, the time is not set automatically.
Automatic setting:
1. Switch on the device using the ON/OFF switch
appears on the display.
2. The display automatically switches to receiver mode. As soon as the device re-
ceives the time signal, the radio clock symbol
until the device has finished receiving the DCF77 signal.
NOTE
If you do not wish to set the time or you want to take a measurement
immediately, exit the time setting mode by pressing the START button.
3. During the automatic time setting procedure, the radio clock
then 2 and then 3 bars above it. When the symbol appears with 3 bars, the time has
been set. First the date and then the time are displayed at the top right of the dis-
play. Then the time is displayed permanently together with the radio clock symbol
.
NOTE
It takes approx. 2 to 4 minutes for the date and time to be set
automatically. If no signal is received within 4 minutes, " - : - - "
appears on the display.
You can now set the clock manually or improve the reception by
moving the device to another location. If you move the device, you
have to re-insert batteries or reset radio clock to ON to restart the
automatic setting.
Manual setting:
Switch the device to standby mode. If you do not press any buttons for 1 minute
during the time setting, the time setting mode switches off and " - : - - " appears in
the clock display.
3 Getting Started
on the back. " - : - - "
flashes on the display every second
flashes first with 1,
GB
29