ProMed MTX Instrucciones De Manejo página 31

4. Press the TIMER button
button to switch between alarm on (
press the TIMER button
acoustic signal sounds at the time you set.
NOTE
If you have correctly entered an alarm time and the alarm is active, the
alarm symbol appears in standby mode. If no alarm is active for either of
the user memories, no symbol appears in standby mode.
3.5 Setting up the user memory
The MTX gives you the opportunity to assign readings to one of two user memories,
each of which provides 99 memory slots. Switch the device to standby mode. Press the
TIMER button to select either user memory 1 or user memory 2.
3.6 Selecting the 3MAM measuring method
With the MTX, you can choose between two measuring modes.
• Single reading
• 3 consecutive readings ( Measurement Average Mode = 3/MAM-mode )
In the case of a single reading, just one blood pressure reading is taken and stored.
The 3/MAM-mode is to be recommended if you suffer from severely fluctuating blood
pressure. 3 successive readings are taken at 15 second intervals, thus eliminating
widely varying readings. In the case of serious deviations, a 4th reading may be taken.
From these three measurements, a weighted average value is calculated, displayed and
stored in the selected memory. A reading taken in this way is indicated in the memory
by an .
The 3/MAM procedure greatly minimizes the risk of an incorrect reading.
1. To switch between single measurement and 3 consecutive measurements (3MAM
procedure), press and hold the TIMER button
mode and "
2. Press the MEMO button to select either "
measuring method and "
3. Confirm your selection by pressing the START button (or press the TIMER button
to make the next setting: " Switch beep on/off ").
and the alarm symbol flashes. Use the MEMO
) and alarm off (
or the START button. Once the alarm has been set, an
" appear flashing in the display.
" for single measurement.
3 Getting Started
) . To confirm your entries,
until the symbol for 3MAM
" or " "; " " for the 3MAM
GB
31