Setting The Alarm - ProMed MTX Instrucciones De Manejo

GB
3 Getting Started
1. You can set the date and time by pressing down the TIMER button
seconds until
2. Press the TIMER button
display and
3. Press the TIMER button
switch the radio clock on or off by pressing the MEMO button.
If the radio clock is switched off, you can press the TIMER button
time manually.
4. The selected user memory appears on the display together with the flashing year.
- Press the TIMER button
- Press the TIMER button
- Press the TIMER button
- Press the TIMER button
- You can set the current date and time (year, month, day, hours and minutes) by
pressing the MEMO button and confirm the date and time with the TIMER
button
before the device returns to standby mode. In standby mode, the time is dis-
played permanently.
NOTE
If, during manual time setting, you press the START button, you exit the
time setting mode.
The date and time values you have entered so far are kept.
" - : - - " is displayed if you did not set the time previously.

3.4 Setting the alarm

Your promed MTX blood pressure meter is equipped with an alarm function, with
which the two users can set three alarm times each, in order to take medication are
regular intervals, for example.
Make sure that the device is in standby mode and your own user memory has been
selected.
1. Press the TIMER-Taste
until the alarm symbol
2. Release both buttons. " 1 " flashes at the bottom right of the display for Alarm 1.
You can use the MEMO button to select Alarm 1, Alarm 2 or Alarm 3.
3. Press the TIMER-Taste
MEMO button to enter the alarm time: first the hours and then the minutes.
30
appears on the display.
again. After you release the button,
appears below this.
again.
again to display the date; the month starts to flash.
again and the day starts to flash.
again to display the time. The hour starts to flash.
again and the minutes start to flash.
. Then the date and time you set are shown twice each in succession
followed by the MEMO button. Hold down both buttons
appears on the display.
. The display for entering the alarm time flashes. Use the
and appear in the display. You can
for several
appears on the
to set the