Service & Maintenance - Dexter power AG230-4.1 Manual Del Usuario

Original Instructions
Press the button at the bottom of the handle allows you to rotate 90 degrees to the left and right.
Live tool indicator
Fig. 6
This tool feathers a live tool indicator which illuminates as soon as the tool is connected to the supply. This warns the user that
the tool is connected and will operate when the switch is pressed.
4. USE
Switch on and off
Fig. 7
To switch on, push the front part of the on/off switch forward then push the main part of the on/off switch down. To switch off,
release the switch.
NOTE: This angle grinder cannot be locked on.
Grinding
Fig.8
WARNING: Never use a cutting disc for grinding. When grinding, only use disc guard for grinding, do not use disc guard for
cutting.
CAUTION: Never engage the spindle lock whilst the spindle is rotating.
The best grinding results are achieved when setting the machine at an angle of 30° to 40°. Move the machine back and forth
with moderate pressure. In this manner, the workpiece will not become too hot, does not discolour and no grooves are formed.
Note: When side grinding and peripheral grinding, also need to keep the angle between the disc and the workpiece surface at
approximately 30 to 40
0
WARNING: The disc continues to turn for a few seconds after the switch is released. Keep your hands well away from the
moving disc.
CAUTION: please support the workpiece properly.
Cutting metal
Fig.9
EN
WARNING: Never use a grinding disc for cutting. For cutting metal, always work with the protection guard for cutting
CAUTION: Never engage the spindle lock whilst the spindle is rotating.
When cutting, work with moderate feed, adapted to the material being cut. Do not exert pressure onto the cutting disc, tilt or
oscillate the machine. Do not reduce the speed of running down cutting discs by applying sideward pressure. The machine must
always work in an up-grinding motion. Otherwise, the danger exists of it being pushed uncontrolled out of the cut. When cutting
profiles and square bar, it is best to start at the smallest cross section.
CAUTION: please support the workpiece properly.
5. SERVICE & MAINTENANCE
Always disconnect the device before performing any adjustment or maintenance operation. If the supply cord is dam-
aged, it must be replaced by the manufacturer or its service anent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged. Take care not to expose this tool to the rain.
Store the accessories in a dry place.
Regularly inspect the accessory, ensure the accessories are free of crack and surface defects. Replace the accessory when it
has worn out.
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of commer-
74
.
0
Dexter Power