Dirna Mini COOL COMPACT Instrucciones De Montaje página 25

Fasten supports tightening nuts until outside
13
EPDM joint (Point 4a) of equipment is com-
pressed, between 3 and 6 mm; joint EPDM
must stay with a thickness of 19 and 22 mm.
Important: To avoid water from filtering in-
side cabin, check EPDM joint tightening with
Minicool base, as indicated on diagram.
3-6mm.
Cabin roof
Fasten selflocked nut until
EPDM gasket is compressed
13
between 3 and 6 mm.
Tighten (4) M8 nuts to support and (4) to Unit
14
base.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Base
EPDM Joint
25
dirna
, s.a.
Check compression
thickness using a tape
measure in the four
corners.
EPDM gasket
EN
13
14