Operation - Lacor 69083 Instrucciones De Uso Y Mantenimiento

1.- Remove the machine and all its accessories. Remove the packaging before using the
appliance. Do not throw away the packaging until having checked to see that the appliance
works properly.
2.- Make sure to place the mixer over a flat, hard surface, avoiding extremely hot areas or other
dangerous elements. Verify that the connection cable and electric plug are in good condition.
3.- Make sure that you have a space greater than 30 cm on both sides of the appliance,
especially in the front (user area).
4.- Before starting the mixer, clean all of the accessories with soap and water, then dry them,
remembering that the motor unit can not be submerged in water, cleaning it only with a
moist rag.
5.- To assemble the accessories follow these instructions:
a.- Place the toggle stand over a solid surface.
b.- Press the toggle button and raise the upper toggle stand 45º
c.- Place the food to be beat, mixed or kneaded in the bowl and place the bowl in its
position.
d.- Press the toggle button and lower the upper toggle stand 45º
e.- Select the proper mixing accessory: beaters or mixers.
f.- Insert the rod into the geared wheel in the left insert (with a geared wheel symbol)
on the motor unit.
g.- Insert the other rod into the other insert of the motor unit.
h.- Place the motor unit with the mixing rods over the toggle stand, making sure that
the cable hangs over its slot. You will hear a click when the motor unit is properly
inserted into the toggle base.
6.- Move the switch-speed selector to the desired speed, and the rods will mix automatically.
7.- Remember that you can press the turbo button at any time, making the rods rotate at
maximum speed.
8.- After completing the beating, mixing or kneading, place the switch-speed selector on "0."
For safety measures, disconnect the power cord from the mains.
9.- Press the toggle button and raise the motor unit 45º with the rods and the upper toggle
base. Remove the bowl with the finished product.
10. Remove the bowl from its position.
11. Press the fastening button and remove the motor unit with the rods.
12. Press the ejector button and remove the rods for cleaning.
If you want to beat, mix or knead with just the motor unit and rods, do not use the toggle base.

OPERATION

21