Operation - Lacor 69194 Instrucciones De Uso Y Mantenimiento

1.- Remove the wrapping before using the electrical appliance. Do not discard the wrapping
until you have checked that the blender is working correctly.
2.- Make sure that the blender is placed on a flat, dry surface. Avoid contact with areas of
excessive heat. Check that the connection cable and the power point are in perfect
condition.
3.- Have fruit or vegetables prepared (for example: cut apple, carrot or other fruit and
vegetables cut into pieces), then add water. Do not exceed the maximum line on the
blender. If you wish to crush ice, add several ice cubes and water and then cover with the
lid.
NOTE:
Do not use foods at a temperature above 50ºC.
4.- Correctly place the crystal jar on the main body or the motor will not operate since the safety
switch inside the main body is not pressed.
5.- Press the desired speed button (1 for soft products and 5 for more solid items), and after 3
minutes of operation, the motor will stop automatically. The time screen will display the
elapsed time.
If you would like to increase the blender speed, press a higher speed than the one initially
selected, and if you would like to reduce the speed, select a lower speed.
6.- You may press the OFF button at any time to stop the motor.
7.- Use the PULSE button for custom blending at the maximum speed.
To chop ice, add a certain amount of water in the jar and press the ICE button.
8.- NEVER use the jar without the lid. The centrifugal force of the blender will throw liquid out
of the jar. This is also a basic safety measure to avoid risks to people.
9.- Make sure that the jar is not used when empty, as well as for very long periods of time, as
this could affect the useful life of the engine. In the event of the engine overheating, switch it
off immediately and wait until it cools down before using it again.
10.- Do not insert spoons or other items during use, as this could cause irreparable damage to
the knives and the engine.

OPERATION

33