FALMEC CAPPE E-ION Manual De Instrucciones página 16

E
ELECTRONIC OPERATION
T: Timer key: pressing this key with the extractor fan switched on will activate the shut-down
function after 15 minutes. It turns off the extractor fan and the light. The active function is
signalled by the flashing red LED light.
The timer function, if activated, will be deactivated by pressing the timer key again. The
function is also deactivated when pressing the 0/1 key if the extractor fan has switched off.
The key lights up permanently, with the extractor fan switched off,
to signal aluminium filter cleaning after 30 hours of operation. Applying prolonged pressure
will reset the signal.
DEC : If the automatic function is active, it will deactivate it. If the extractor fan is active, it
reduces the speed.
0/1: If the automatic function is active, it will be deactivated. If the extractor fan is switched
off, it activates it at the first speed. If the extractor fan is in operation, it switches it off.
INC: If the automatic function is active, it will be deactivated. If the extractor fan is operat-
ing, pressing the key
will increase speed up to the maximum for four speed hoods. The maximum speed has a
duration of 14 minutes, after which the extractor fan will return to the 3rd speed. The maxi-
mum function is signalled by the flashing INC LED. Please Note: in hoods with 2 motors (for
example Sping and Libra), 3 speeds are active and the maximum speed is not timed.
Auto: With extractor fan automatic mode activated/deactivated; if activated, the auto LED
lights up.
In this mode, if air quality is good (completely green leaf), the extractor fan
and the ioniser are switched off. If the quality of the air has deteriorated, the leaf is partially
or completely
yellow, the extractor fan is activated at the first speed and the DEC LED lights up until the
leaf turns completely green.
L: Brief pressing activates/deactivates the light.
F
FILTERS
1. METAL FILTERS
To remove the metal filters, remove the lower panel fastened with one of the magnets of
the range hood. This way, the filters can be removed by using the appropriate handle.
2. COMBINED AND REGENERABLE FILTERS (qualified personnel only)
The CARBON-ZEO filters can be regenerated according to the procedures described in
paragraph H regarding maintenance. These filters are placed in the upper side of the
range hood. Follow the instructions below to remove them (see fig. F2):
- Disconnect the appliance from the mains.
- Loosen the 2 screws (V1) (4 screws for SPRING double motor range hood).
- Carefully remove the combined filter-holder (SF) (2 filter-holders for the SPRING double
motor range hood)
14
REMOVING AND REPLACING'S INSTRUCTIONS