Amprobe IR-710 Manual De Uso página 127

Rotary Switch Positions
Button
Press YELLOW button to toggle between MAX, MIN, DIF, AVG, HAL, LAL, DATA and
YELLOW
T-C options. When the Thermometer goes into sleep mode, press MODE to turn the
button
thermometer ON again and it displays the last measurement result.
Press to enter set-up mode stepping through Emissivity, Trigger Lock and Switching °C/°F
set-up.
SET
Details refer to the below Emissivity, Trigger Lock and °C / °F set-up.
Press
Selectable two level of display backlight to adapt different lighting conditions.
Press
When the thermometer enters the setup up mode (SET), press
option (Emissivity, Trigger lock, Switching °C / °F).
/
When the thermometer enters HAL, LAL and DATA mode, press
option (Emissivity, Trigger lock, Switching °C / °F).
Laser
�
Caution
To avoid injury, do not point the laser directly at eye or indirectly off reflective surfaces.
The thermometer is equipped with a laser used for aiming purposes only. The laser turns off when the trigger
is released.
To enable or disable the laser:
1. Press button to enable or disable the laser. Symbol appears on the display when laser is enabled.
Emissivity set-up
1. Press SET button to select Emissivity set-up, icon
2. Press to increase the value by 0.01. Press and hold
3. Press to decrease the value by 0.01. Press and hold
4. Press MODE button to complete the setting and exit Emissivity set-up, or press SET button to complete the setting
and continue setting for Trigger Lock.
Note: Default emissivity is 0.95.
to turn the display backlight ON or OFF.
to turn the laser light ON or OFF.
symbol on the display Indicates laser light is ON.
Description
is blinking on the display
for quick setting. The maximum value is 1.00.
for quick setting. The minimum value is 0.01.
5
or to select a set-up
or to select a set-up