Improper Uses; Tool Transport; Maintenance; Routine Maintenance - CAMPAGNOLA VICTORY Manual De Uso Y Mantenimento

Campagnola Srl
IMPORTANT: If the above-mentioned remedies do not solve the problem, contact an Authorized Service Point.

5.4 Improper uses

- Never use the tool when your balance is unstable.
- Never cut materials being other than wood.
- Never use the tool as a lever or for lifting, moving or breaking any objects.
- Never use the tool if the atmosphere is explosive or inflammable.

5.5 Tool transport

Disconnect the tool from the air supply before carrying it.
In case of long transports keep the tool in its packaging.
WARNING!
Use the tool only for the purposes described in par. "Product Description". Any other use can cause injuries
and damages.
6.

MAINTENANCE

6.1 Routine maintenance

WARNING!
Before carrying out any maintenance operation, disconnect the tool from the compressed air hose.
All the maintenance operations which are not described in this manual have to be performed by a CAM-
PAGNOLA S.r.l. Authorized Service Point.
The routine maintenance operations may be carried out by the operators.
Any routine maintenance operation can be carried out by the operator.
6.1.1

In general

Before any maintenance operation:
•
Engage the safety catch (5).
•
Disconnect the air hose.
•
Wear heavy-duty protective gloves.
WARNING!
Do not use hydraulic oil or brake fluid. These may cause irreparable damages to the tool.
•
Periodically check the oil level in the compressor lubricator.
•
6.1.2

Lubrication

•
Every 20 working hours lubricate the inner part of the fitting (26) with an oiler. Keep the shear vertical.
•
Every 20 working hours lubricate the conrod (21) with an oiler. When carrying out this operation, wear heavy-duty
protective gloves and manually close the blades (4-8) till the conrod (21) protrudes.
6.1.3

Blade group adjustment

•
Gradually tighten the screw (13) until the blades (4-8) work well.
6.1.4

Blade sharpening

•
Every 2 working hours sharpen the blade cutting edge (4) by means of an adequate filing stone (picture G).
IMPORTANTE!
The sharpening filing angle must be 45°
6.1.5 Cleaning – Storing the tool
•
Before storing the tool at the end of the working season, it is recommended to clean it, to add few drops of diesel fuel into the
air hose fitting (26) in the hand grip and to pull the operating lever (3) few times while the tool idles. This operation will avoid any
dirt or moisture residues inside the tool
USE AND MAINTENANCE MANUAL – Translation of the original Instructions
Ver.1.0 - Rev.: 01, Date: 20/10/2014
.
Pag. 27