Electrical Connection; Connecting To The Mains Supply; Using The Appliance; Description Of The Functions - Saivod Timer Dry Manual De Instrucciones

Make sure that the voltage
indicated on the identification
plate attached to the back of the
appliance corresponds to that of
the mains supply.
On completion of the installation,
the appliance must be connected
to the mains supply through a
two-pole switch.
All cutouts, electric wiring and
mains sockets must have a rating
such that enables them to support
the maximum load indicated on
the identification plate.
The mains supply to which the
appliance is connected must be
fitted with an earthing system. If
9
10
0
1
11
INSTALLING THE APPLIANCE

ELECTRICAL CONNECTION

8
this is not the case, the
manufacturer will not be held liable
for any incidents that may occur
(fig. 8).
If the power supply cable is
damaged in any way, contact the
appropriate specialised customer

USING THE APPLIANCE

DESCRIPTION OF THE FUNCTIONS

Drying time control knob: Rotate the knob to select the required
drying times (fig._9). Refer to the program table to select the
program according to the type of fabric.
At the end of each drying cycle, the appliance effects a 10 – 15
minute cooling cycle, during which time the appliance is still switched
on.
N.B. The timer knob must always be rotated clockwise (fig. 9).
START button: Press this button to start the drying cycle (the
indicator will light up) (fig. 10).
Delicate or energetic drying button: This button is used to se
lect the type of drying cycle to run: Energetic or delicate (fig.11).
technical service centre.
The drier must not be connected
to the mains supply using indirect
methods such as extension leads
or multiple adapters.
Position the appliance so that the
power supply cable is easily
accessible for disconnection when
the need arises.
Important: On completion
o f t h e d r y i n g c y cl e ,
disconnect the appliance
from the mains supply to
prevent young children
from operating the drier.
GB
7