Enerpac W Serie Hoja De Instrucciones página 7

4 13
5 14
Fig. D
• Push the release lever (7) back into
the fastener head (2). Make sure the
ball detent clicks into place.
Do not operate the tool if the head
release lever is not fully closed.
3.3 To connect the hoses (fig. D)
Make sure all accessories meet the
pressure requirements.
Make sure the quick connect
couplings are securely attached
before operating the tool.
The tool is fitted with male and female
quick-connect couplings. Use Enerpac
twin safety hoses only. Refer to the table
below.
Hose model number Description
THQ-706T
THQ-712T
• Remove the hose dust caps.
• Connect the hose with the female
coupling (13) to the advance coupling
(4).
• Pull the sleeve on the female coupling
of the hose over the advance
coupling.
• Tighten the sleeve.
• Connect the hose with the male
coupling (14) into the return coupling
(5).
• Pull the sleeve on the return coupling
over the male coupling of the hose.
• Tighten the sleeve.
• Fit the hoses to the pump.
Refer to the pump instruction manual.
Two hoses, length
6 m (19.5 feet)
Two hoses, length
12 m (39 feet)
7