Safety Devices - Comet CRRC 50 ECO L Manual De Instrucciones

WARNING
• Should one or more plates deteriorate during use, contact the Manufacturer or a
to have them restored.
a) Trolley kit ID plate.
The identification plate (6) shows the barrow/trolley kit model, the main technical specifications and the year
of manufacture. It is located on the base (9) of the trolley kit.
b) Motor pump ID plate.
The identification plate (37) shows the motor pump model, the serial number, the main technical specifications
and the year of manufacture. It is located on the base of the motor pump (all versions with combustion
engine, MTP MC 20/20 and MTP MC 25 with electric motor), or on the power box (other motor pumps with
electric motor).
c) Machine's technical data CE plate.
The CE plate (45) shows the barrow/trolley model, the year of manufacture and the main technical
specifications, including the empty weight, tank capacity and full loading weight. It must be applied on a
clearly visible part of the base (9) by the SKILLED TECHNICIAN
d) Caution plate.
The caution plate (11) points out some of the dangers there could be when using the machine. This plate is
located on the tank (16). The meanings of the pictograms used are given in the following table:
a No smoking
b Read the instruction manual
c Do not stay inside the machine's range of action
d Do not discard waste in the environment
e Do not remove the safety devices
f Do not clean or lubricate when the machine is functioning
g Do not drink! Not drinking water
e) Symbol .
This machine is marked with the separate waste collection symbol regarding disposal of electrical and
electronic material (WEEE).
This means that this product must be taken to a separate waste collection centre in compliance with the
European Directive 2002/96/EC so it can be recycled or dismantled and thus reduce any impact it could have
on the environment.
For more information about this we suggest you contact your local or regional authority.
The electronic products that are not subject to separate waste collection are potentially harmful for the
environment and for human health due to the presence of hazardous substances.
a) Pressure unloader/regulation valve.
This valve is suitably set by the Manufacturer and allows regulating the operating pressure and permits the
pumped fluid to flow back towards the bypass duct, thus preventing the accumulation of dangerous pressures
when the delivery line is closed or when attempts are made to set pressure values above the maximum
ones allowed. A pressure unloader/regulation valve featuring pumped liquid on/off devices (such as taps)
is usually called control unit.
WARNING
• The pressure unloader/regulation valve is set by the Manufacturer. Never try and adjust the pressure
IDENTIFICATION AND CAUTION PLATES

SAFETY DEVICES

h Toxic products
i Corrosive products
l Wash your hands after each use
m Wear gloves
n Wear a protective mask
o Wear ear protectors
p Wear protective clothing
SKILLED TECHNICIAN
EN
31