Environmental Protection; Maintenance And Cleaning; Declaration Of Conformity - Bosch PEX 400 A Instrucciones De Servicio

Ocultar thumbs Ver también para PEX 400 A:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Application Table
The following table should be used only as a recom-
mendation.
The most suitable combination for the work to be per-
formed is best determined by practical trials.
Material
Grain
Rough
sanding/
Fine
sanding
Paint
180/400
roughing
Paint
120/240
touch-up
Paint
40/80
removal
Softwood
60/240
Hardwood
60/180
Veneer
240/320
Aluminium
80/240
Steel
60/240
Rust removal
40/120
from steel
Stainless steel
120/240
Polishing (PEX 400 AE)
For polishing, fit the eccentric sander with an appropri-
ate polishing tool.
Select a low speed for polishing (step 1–2) to
avoid excessive heating of the surface.
Apply polishing agent crosswise or in a circular motion
with a sponge and moderate pressure and then allow
to dry lightly.
Polish the partially dried polishing agent with cross-
wise or circular motions using a lamb's wool polishing
bonnet.
Cleaning the polishing tools.
It is recommended to wash the polishing tools with a
mild detergent and warm water (do not use paint thin-
ning agents).

Maintenance and Cleaning

Before any work on the machine itself, pull the
I
mains plug.
For safe and efficient working, always keep the ma-
I
chine and the ventilation slots clean.
2 609 932 202 • (02.08) T
Thumbwheel
Sanding
Position
plate
(PEX 400 AE)
3
Medium
5
Hard
4
Medium
5
Soft
5
Medium
4
Soft
4–5
Medium
4
Medium/
Hard
6
Soft
4
Medium
English–4
WARNING
Important instructions for connecting a new 3-
pin plug to the 2-wire cable.
The wires in the cable are coloured according to the
following code:
Strain relief
Live = brown
Neutral = blue
Do not connect the blue or brown wire to the earth ter-
minal of the plug.
Important: If the plug on the cable of this machine
must be replaced, dispose of the old plug to prevent
misuse.
If the machine should fail despite the care taken in
manufacture and testing, repair should be carried out
by an authorised customer services agent for Bosch
power tools.
For all correspondence and spare parts orders, always
include the 10-digit order number of the machine.

Environmental Protection

Recycle raw materials instead of disposing as
waste.
The machine, accessories and packaging should be
submitted for environment-friendly recycling.
These instructions are printed on recycled paper man-
ufactured without chlorine.
The plastic components are labelled for categorised
recycling.

Declaration of conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 50 144 according to the provisions of the direc-
tives 89/336/EEC, 98/37/EC.
Dr. Gerhard Felten
Senior Vice President
Engineering
Robert Bosch GmbH, Geschäftsbereich Elektrowerkzeuge
Specification subject to alteration without notice
To be fitted
by qualified
professionals only
Dr. Eckerhard Strötgen
Head of Product
Certification

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pex 400 ae

Tabla de contenido