General Information; Instructions For Use; Preparation For Installation - Varian Turbo-V 1000 ICE Manual De Instrucciones

GENERAL INFORMATION

This equipment has been designed to be used by
professionals. The user should read this instruction
manual and any other additional information supplied
by Varian before operating the equipment. Varian will
not be held responsible for any events occurring due to
non-compliance, even partial, with these instructions,
improper use by untrained people, unauthorized
interference with the equipment or any action contrary
to that provided for by specific national standards. The
Turbo-V 1000 ICE
microprocessor-controlled,
converters with self-diagnostic and self-protection
features.
The controllers drive
Turbo-V 1000 ICE E-series pump during the starting
phase by controlling the voltage and current respect to
the speed reached by the pump. They incorporate all
the facilities required for the automatic operation of the
Turbo-V 1000 ICE E-series.
Remote start/stop commands, pump status signals,
forepump start/stop commands,
signals (for pressure switch, water flow switch), heater
jacket control signals, flow meter control signals and
purge valve management signals are provided via
auxiliary connectors. The following paragraphs contain
all the information necessary to guarantee the safety of
the operator when using the equipment. Detailed
information is supplied in the appendix "Technical
Information".
This manual uses the following conventions:
!
The warning messages attract the operator's attention
to a particular procedure or practice that could lead to
serious injury if not followed correctly.
The caution messages
procedures that could cause damage to the equipment,
if not followed correctly.
The notes contain important information taken from the
text.
E-series controllers
solid-state, frequency
(within ten steps)
interlock control
WARNING!
CAUTION!
are displayed before
NOTE
STORAGE
When transporting and storing the controllers, the
following environmental
satisfied:
•
temperature: from -20 °C to + 70 °C
•
relative humidity: 0 - 95% (non-condensing)

PREPARATION FOR INSTALLATION

The controller is supplied in special protective packing.
are
If this shows signs of damage that may have occurred
during transport, contact your local sales office. When
unpacking the controller ensure that it is not dropped or
subjected to any form of impact. Do not dispose of the
the
packing materials in an unauthorized manner. The
material is 100% recyclable and complies with EEC
Directive 85/399.
Each controller is factory set for a specific power
supply:
•
model 969-9464 is factory set for 220 Vac
operation
•
model 969-9564 is factory set for 120 Vac
operation
Check voltage selector window for correct set and
connect power cord.
45

INSTRUCTIONS FOR USE

requirements
Controllers Packing
87-900-951-01 (B)
should be