Zeiss Primo Star Instrucciones De Manejo página 38

Carl Zeiss
Fig. 27 Setup User menu
Date / Time
Flip image
Load Settings
Save Settings
Startup Set
Fig. 28 Technical Info menu
Version
MAC
IP
Destination IP
NETMASK
38
Start-Up and Operation
Date and time in year-month-day / hour-minute-second format.
Each element can be adjusted using the up / down buttons. The new time can be set by pressing
the OK button. Date and time are integrated into the folder and file names on the SD card.
The following modes are available for image mirroring:
FLIP H+V: horizontal and vertical mirroring
FLIP V: only vertical mirroring
FLIP H: only horizontal mirroring
OFF: no mirroring
Default setting: the image position on the monitor or iPad corresponds to that in the eyepiece.
The previously saved user settings (USER 1-4) can be loaded in this menu.
Selecting "FACTORY DEFAULT" reinstates the default camera settings. After confirmation with
OK the camera will be restarted. This may take several seconds.
If the OSD menu is not available, the factory settings can be reinstated using the short-cut
"Snap" + "AWB / OK" (keep depressed for two seconds).
The current settings can be saved in a user storage location (USER 1-4).
They can be automatically loaded in the "Load Settings" (see above) or "Startup Set" menus (see
below) at a later point in time or each time the camera is switched on
Please observe the following: If the settings are saved, "Startup Set" is automatically set to this
storage location.
This setting determines which user storage location (USER 1-4) is to be loaded each time the
camera is switched on.
Current firmware version
MAC address of the built-in camera
Currently used IP address
Currently used multicast target address
Currently used netmask
415500-7344-008
Primo Star / Primo Star iLED
11/2013