Visualization Of Data Via Hdmi Port - Zeiss Primo Star Instrucciones De Manejo

Primo Star / Primo Star iLED
3.5.3.3

Visualization of data via HDMI port

The binocular tube with integrated camera can be connected to a monitor, TV or projector for
visualization of the live image data.
The data at the HDMI output is in DVI format. Further HDMI functions (e.g. audio,
communication between monitor and camera) are not supported.
To enable the display the high-resolution images in HD format in this quality, it is
recommended that only HD-capable devices be connected.
• Connect the monitor / projector to the binocular tube 30°/20 using the HDMI cable.
To do this, insert the HDMI plug (Fig. 22/1) into the jack on the reverse side of the binocular tube
30°/20 (Fig. 22/2) and the monitor / projector (Fig. 22/3).
Secure the HDMI plug on the jack on the monitor / projector.
Fig. 22 Connecting the binocular tube 30°/20 to a monitor / projector
If a monitor / projector is used, an HDMI / DVI adapter cable (Fig. 22/4) or HDMI / DVI adapter
will be required for the reproduction of image data.
A default resolution of 720p60 has been set.
• For further camera settings using the on-screen display menu (OSD) see section 3.5.4.
Live image data can be documented by photo or video recording, see section 3.5.3.1.
• Connect the binocular tube to the mains supply, see section 3.5.2 on page 31.
The visualized images of the integrated camera may only be used for training and research.
Direct generation of diagnostic results from these image is not proposed.
11/2013
Start-Up and Operation
415500-7344-008
Carl Zeiss
33