Video Tampering - Abus TVVR33004 Manual De Instrucciones

Video Tampering

Select the camera channel to be processed under
"Camera".
Tick the "Enable Video Tampering Detection" box and
define any other optional parameters under "Settings".
The sabotage alarm is activated if there is any tampering
with the camera lens (sharpness, dimming).
Arming Schedule
Select the Arming Schedule tab.
Here you set the times at which the reactions set in the
Linkage Action tab are triggered.
1. Select the day and enter the schedule.
Note
Up to eight time slots, between 00:00 and 00:00,
can be defined in each case, but the individual
time slots must not overlap.
2. Under Copy, select whether or not the setting should
be applied to every day of the week and the holiday
settings.
103
3. Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
Linkage Method
Select the Linkage Action tab.
Here you can configure the response of the recorder
during an event (e.g. motion detected) by ticking the
corresponding box.
Parameter
Full Screen Monitoring
Audible Warning
Notify Surveillance
Centre
Send Email
Trigger Alarm Output
Confirm the settings by clicking on Apply and exit the
menu by clicking on OK.
Camera
Notifications
The camera is displayed in
full screen in live view.
The device emits a
repeated signal tone.
The CMS sends out a
warning message.
An email is sent to a
specified email address.
See page 92.
The alarm output is
triggered in the event of an
alarm.