Cleaning And Maintenance; Technical Specifications - HQ-Power VDP3000SMN Manual Del Usuario

Remote controller
1. Up
2. Function
3. Display
4. Down
5. TIME button
6. OUTPUT button
7. LOCK button
Plug the remote control into the rear of the smoke machine. Once the smoke machine is connected to the
mains and switched on, the main switch will light indicating the unit is receiving power. The bar beneath the
HEAT indication on the remote control display will blink. After a warm-up time of ± 5 minutes, the blinking bar
will switch to OK, indicating the unit is ready.
Use FUNCTION to move through the various features. Adjust the settings with - or + and press OUTPUT to
produce the fog.
ADD DMX address
MU Minutes. Time between two bursts.
SE Seconds. Time between two bursts.
Volume of fog output in 10% increments. To create a steady output, adjust the volume
VO
and press .
Timer function. This function allows you to set the operation time of the smoke machine.
OUTPUT Press to start or to stop the fog production.
Lock. Used to produce a steady output.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. Mechanically moving parts must not show any signs of wear and tear.
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts.

7. Technical Specifications

Power Supply
Power Consumption
DMX in-/outputs
Controller
Smoke liquid
Cleaning liquid
Dimensions
Total Weight
For more info concerning this product, please visit our website www.hqpower.com.
The information in this manual is subject to change without prior notice.
VDP3000SMN_v4
max. 230Vac/50Hz
max. 300W
3-pins XLR
5-pin XLR
VDLSL5 or VDLSLHT5
VDLCL
665 x 382 x 318mm
16kg
5
HQPOWER