Picture
Symptom
While editing using the DV connecting
cable, recording picture cannot be
monitored.
Others
Symptom
The camcorder becomes warm.
The supplied Remote Commander does
not work.
The CHARGE lamp flashes after you
charge the battery pack installed in the
camcorder.
No function works though the power is
on.
AC power adaptor
Symptom
The VTR/CAMERA or CHARGE lamp
does not light.
The CHARGE lamp flashes.
Cause and/or corrective actions
• Remove the DV connecting cable, and connect it
again.
Cause and/or corrective actions
• If the power of the cammcorder is on for a long time,
it becomes warm, which is not mulfunction.
• COMMANDER is set to OFF in the menu system.
m Set it to VTR4 or ID. (p. 86)
• Something is blocking the infrared rays.
m Remove the obstacle.
• The battery is not inserted with the correct polarity.
m Insert the battery with the correct polarity. (p. 86)
• The batteries are dead.
m Insert new ones. (p. 86)
• The camcorder is not malfunctioning.
• Disconnect the connection plug on the battery pack or
on the AC power adaptor, then reconnect it in about 1
minute. Turn the power on. If the functions still do
not work, press the RESET button on the back of the
cassette compatment lid using a sharp-pointed object.
(If you press the RESET button, all the settings
including the date and time return to the default.)
(p. 82)
Corrective actions
• Disconnect the power cord. After about 1 minute,
reconnect the power cord. (p. 7)
• See the chart on the next page.
DCR-PC7.3-858-174-22 (E,S)
73