Beper 50.937 Manual De Instrucciones página 12

Steam Station Use instructions
INSTRUCTIONS FOR USE
Before first use, please ensure that the wattage and mains voltage correspond to the in-
structions on the rating label.
Ensure that the power cord is not damaged by being crused, kinked or scaped against
sharp edges. If the replacement of the supply cord is necessary, this has to be done by the
manufacter or his agent in order to avoid a safety hazard.
When using the steam station for the first time, take off the protection film of the plate.
During the first use, a light smoke caused by the evaporation of the protective oil applied
in manufacture may appear ; this is normal and after some use the smoke will disappear.
The steam station may contain some residues in the boiler or steam tube. During the first
use of the domestic iron, , make leave several times the steam in order to eliminate the
internal residues
Never pull the supply cord to unplug the appliance.
Do not roll up the electric cord around the iron.
Keep away to a reasonable distance the supply cord from the iron plate, especially when
it is hot.
When making a break or if not used, put the iron on the iron rest in vertical position.
Do not leave the steam station plugged, without supervision.
Refill the tank with water before plugging the appliance. During filling and refilling we re-
commend to unplug the appliance from the mains supply.
Do not fill the tank over his maximum capacity.
Do not fill with mixture stain-removing, vinegar, scaling or chemical agent, but use only
distilled or demineralised water.
Lay the steam station on a plane surface, stable and resistant to heat.
The plate of the iron becomes very hot, take care not to burn you.
Never direct the jet of steam towards your face.
Always choose the right temperature according the cloth which has to be ironed.
Do not use the stream station as a heater. Do not iron the wet clothes, let them dry before
ironing. Do not iron clothes when wearing them on you.
Do not pass the iron on buttons or zipper in order to not to damage the plate.
Take care not to knock the iron. Do not touch the parts of iron when this one is on and in
the minutes following the extinction to avoid any risk of burns.
Do not put the hot iron on the electric cord. Pay attention that this one does not touch the
hot plate of the iron.
Do not open the tank during the use.
Before cleaning, unplug the supply cord.
After complete cooling you can store the appliance.
If you no longer use this appliance, please keep away from children.
12