Skoda EEA 400 001A Instrucciones De Montaje página 26

8353_TAZNE_ZAR_FABIA/MN/.fm Page 25 Wednesday, September 8, 2004 9:17 AM
- 4a -
- Unscrew the M10 nut (F
supporting board (G
- 4b -
- Unscrew the M10 nut (F
the lower supporting board (G
and the clamping bolt with the hook (E
- 5a -
- Turn the bumper so that the upper painted side is pointing upwards.
- Place the lower supporting board (G
four screws go through the drilled holes -arrows-.
- 5b -
- Place the cutting board (H
ting upwards. Place this assembly on the upper painted side of the bumper so that the
supporting board's two screws go through the outlying drilled holes.
- Place the upper supporting board (l
hand and lightly tighten the two nuts (F
Beware of damaging the paintwork on the bumper!
Visually inspect the positioning of the completed cutting template. If necessary, gently
straighten its position with regard to the lower edge of the bumper within the frame-
work of the play between the screws and the pre-drilled holes.
Now tighten the nut so that the bumper walls are straightened between the cutting
board and the upper supporting board -detail-.
- 6a -
- Place the cutting board (H
lower supporting board (G
bumper. Lightly tighten the complete assembly using the M10 nuts (F
Beware of damaging the paintwork on the bumper!
Visually inspect the position of the completed cutting template. If necessary, gently
straighten its positioning with regard to the lower edge of the bumper within the frame-
work of the play between the screws and the pre-drilled holes.
- 6b -
- Thread the two clamping bolts with the hooks (E
the upper painted side of the bumper and hook them onto the edge of the lower sup-
porting board (G ).
2
- Screw on the two remaining M10 nuts (F
Black process 45.0° 141.0 LPI
) and divide the cutting assembly into three parts – the lower
1
), the cutting board (H ) and the upper supporting board (l
1 1
) and divide the cutting assembly into the following parts –
2
), the cutting board (H
2
).
2
) onto the lower side of the bumper so that its
1
) on the lower supporting board (G
2
) on the lower side of the bumper. Press it by
2
) of the assembly.
2
) and the upper supporting board (I
1
), which protrude from the upper painted side of the
1
) from the other side of the assembly.
2
), the upper supporting board (l
2
) with the blade poin-
2
) on the screws of the
1
).
1
) through the cutting assembly from
2
).
1
)
2